The two parts are held together by an M4 countersunk screw. Total length 10mm, thread length 6mm.
Fit the two parts together finger tight and test position by holding the front part and finding the perfect grip and balance for the pistol. Now rotate the rear part so the hooked lug is at the top and remove the pistol and tighten the countersunk screw whilst ensuring the two parts do not rotate out of alignment.
Now fit the bracket to the Skadis board and fit the pistol.
This can be used for real steel, airsoft, air pistols and most other types of handgun.
Pistol Bracket Skadis Rear Screw.stl - will accept an M1.4 self tapping screw of length 8-10mm
Pistol Bracket Skadis Rear Screw M3.stl - will accept an M3 countersunk bolt of length 8-10mm and also a wider range of larger diameter self tapping screws.
Pistol Bracket Skadis Rear Screw M3 Round.stl - will accept an M3 machine head bolt of length 8-10mm and also a wider range of larger diameter self tapping screws.